There are no much changes in the cone crusher work principle and main structure. But the tapered broken pop eccentric parts changed a little. The drum-shaped surface is in the lower part of the main shaft, the bushing holes uses spherical mapping (spherical roller bearing are also commonly used in Western countries). In this way, it reduced the clearance, increased the crushing force arm and improved force situations of spindle and eccentric bushings.
In domestic, rotating disk crusher has successfully applied to superfine gold crushing and gold addressing factories. It remains to be seen for iron ore application. At present, the biggest medium and fine crushing cone crushers in the world are only two types, which are Symons cone crusher and 3000 series produced in former Soviet Union. These crushers are developed by increasing size on the basis of traditional crushers.
In addition, crusher precession angle reduced from the original 2 degrees to 1.6 and 1.5 degrees. Swing times are also correspondingly increased of the fixed cone. So, it increases the crushing force and reduces eccentric parts clearance. Crushing machines modified as follows: It forms crushing cavity between movable cone liner and fixed cone liner. Fixed cone is installed in the upper rack, and movable cone bearing is supported by spherical bearings. Under the spherical bearing seat is a set of circular spring, which installed inside the spindle. The lower part of spindle is fixed on the bottom of rack, the upper part is matched with eccentric sleeve.
For a car to be called as salvage, the degree of the damage the vehicle suffered has to be equal to 75 percent or more of the vehicle's valuation. However, this specific amount can vary from one state to another and some states such as New Jersey, Oklahoma, New York, Oregon, New Mexico, Maryland, Georgia, Minnesota, Illinois, Florida and Arizona even award these types of salvage titles to stolen vehicles that were recovered.
- https://www.affordablecebu.com/