Why won't my printer turn on?

"This issue may be due to any of the following:

1. The power cord is not connected to outlet

Solution: Before attempting to fix the power button, make sure the cord is plugged into a working outlet

2. The power is not on

Solution: Turn on the power by pressing the large square button on front right side of printer.

3. Your printer has a faulty power connection

Solution: Reconnect to power supply. Try unplugging the power cord, pausing for 15 seconds before reconnecting to wall.

4. Your printer is connected to a bad wall outlet

Solution: Utilize a different wall outlet.

Please refer to this device's troubleshooting page for more information."

Faced similar situation... It was working an hour ago and stopped turning on all of sudden... Checked power cable... Tested the cable by putting it in my cam charger... It was fine... Shaked power point as sometime it's due to loose connection... Still no fix... Finally shakes the cartidge box gently... Cleaned the printer.... Connected power cable again and this time it does turn on... What a relief.... Try it... If it works for you as well... Good Luck

"You can reset your printer by following this:

1) Turn the printer off

2) Press and hold the STOP button for 3 seconds.

3) Then press the ON button and release the STOP button.

4) While holding the ON button, press the STOP button 5 times.

5) Release all buttons.

6) LCD Screen should turn on and be blank. After a minute or better turn the printer off once more.

This should be the reset."

I suspect they engineered these to fail after so many years. I wouldn't often use the printer but when I used it I needed it. The ink would mysteriously disappear even when I wasn't using it and I had to buy ink cartridges for it often. So that is what I was doing. I turned the printer on, opened the ink door and checked the number on the cartridges. Closed the door then went into the other room to buy the ink. When I returned to the machine the power was off and I could not turn it back on. Changing outlets, reinserting the power cord, and holding down the power button to no avail. It was meant to fail. I will never buy another printer or product for that matter from Canon.

If you'r printer isn't turn on then you can check first you wire is properly connected or not then Reconnect to power supply. Try unplugging the power wire, pausing for 15 seconds before reconnecting to wall.

"Dear Friends Its Very Easy To Fix This Problems With Normal Steps -

Restart Printer Using The Power KeyReset Your Printer And check the Printer Power Supply

Gud Luck"