bottom charge / pulse sensor

bottom charge / pulse sensor My aplle watch bottom cover came off with the charger and the ribbon cable is broken. The two small cables for charging are still intact and I can still charge the watch but the pulse sensor is not working. where I can buy replacement sensor?
Asked by: Guest \| Views: 272

Total answers/comments: 5

Comments display order:

Guest [Entry]

"when you remove the bottom cover you will see this

. Just unplug the connector, and remove the black tape from the two tiny charging cables. one of them is marked with red or white and it must be soldered to the upper point

. and that's it. only the part is hard to find. I used broken watch to take the sensor but it is good to have a new/replacement one too"

Guest [Entry]

"Is this the part that is needed to be replaced for fixing this issue?

Apple Watch (38 mm, Original & Series 1) Rear Cover"

Guest [Entry]

Hi so the watch charges with the two antennas attached and not the ribbon

Guest [Entry]

So when I solder the two wires back do they need to go in the old solder or can I just put the wires on top then solder over them? The charging wires came off

Guest [Entry]

the Wires go on separate pads the one with the white marking goes to the right if I can remember research to be accurate but I put the wire on the pad and took my solder iron and press down delicately until the solder became liquid tweezer would help also a magnifying but I used neither and actually I didn’t have a solder tip at the time just used the hot coil from the iron and the solder pad that was already there didn’t bother with the hr didn’t have the tools definitely recommend microscope for that